kasunmax01
08-10-2010, 04:16 PM
;):yes:...
today im going to tell you how to by-pass rapidsahre without any software.;):yes:
important:-
this is available only for guys with dynamic ip , from isp provider, not from the isp who give you an static ip!!!:yes:
ok here we go....
To start off, you need a direct connection to your modem and computer. If you have a router, disconnect it and directly hook up your modem to your computer.
1. Open up the command prompt by pressing Start->Run and typing in cmd
2. In the command prompt, type “Ipconfig/all”. This will tell you your current IP Address. After, type “ipconfig/release”. Keep the command prompt open for easy access.
3. Go to “Network Connections” (accessible through the control panel). Right click “Local Area Connection” and click “Properties”
4. With “Internet Protocol (TCP/IP) selected, click the “Properties” button.
5. A new window will open. Under the “General” tab, select “Use the Following IP address”. Under “Ip Address”, put “10.0.0.1?. Press the “Tab” key on your keyboard.
6. Press Ok on both open windows.
7. Repeat steps 3-4. Under the “General” tab, press the radio button “Automatically Assign Me an Ip Address”. Press ok on both windows.
8. Go back to the command prompt and type in “Ipconfig/all”. You’ll now notice you have a new IP address.
repost nam sorry wenna:yes:
post eka hodainam +reps add karala yanna.
today im going to tell you how to by-pass rapidsahre without any software.;):yes:
important:-
this is available only for guys with dynamic ip , from isp provider, not from the isp who give you an static ip!!!:yes:
ok here we go....
To start off, you need a direct connection to your modem and computer. If you have a router, disconnect it and directly hook up your modem to your computer.
1. Open up the command prompt by pressing Start->Run and typing in cmd
2. In the command prompt, type “Ipconfig/all”. This will tell you your current IP Address. After, type “ipconfig/release”. Keep the command prompt open for easy access.
3. Go to “Network Connections” (accessible through the control panel). Right click “Local Area Connection” and click “Properties”
4. With “Internet Protocol (TCP/IP) selected, click the “Properties” button.
5. A new window will open. Under the “General” tab, select “Use the Following IP address”. Under “Ip Address”, put “10.0.0.1?. Press the “Tab” key on your keyboard.
6. Press Ok on both open windows.
7. Repeat steps 3-4. Under the “General” tab, press the radio button “Automatically Assign Me an Ip Address”. Press ok on both windows.
8. Go back to the command prompt and type in “Ipconfig/all”. You’ll now notice you have a new IP address.
repost nam sorry wenna:yes:
post eka hodainam +reps add karala yanna.