මෙම software 1 k භාවිතා කරපු කෙනෙක් ඉන්නවාද

baba2

Well-known member
  • Mar 12, 2013
    1,649
    44
    48
    මෙම software 1 k භාවිතා කරපු කෙනෙක් ඉන්නවාද

    PTDD Partition Table Doctor 3.5
    මම බූටබල් හදා ගත්තා හාඩ් ඩික්ස් එක රිකවඅරි කරන්න ඒත් මොකද්ද කොමාන්ඩ් එකක් ටයිප් කරන්න කියනවා
    එතනින් එහාට සීඩෟ බූට් වෙන්නෙ නෑ.මෙන්න මෙතන ටයිප් කරන්න අවශ්‍ය මෛානවද

    [DR-DOS]A:\>මෙන්න මෙතන ටයිප් කරන්න අවශ්‍ය මෛානවද
     

    baba2

    Well-known member
  • Mar 12, 2013
    1,649
    44
    48
    english??????????????
    PTDD Partition Table Doctor 3.5
    මම බූටබල් හදා ගත්තා හාඩ් ඩික්ස් එක රිකවඅරි කරන්න ඒත් මොකද්ද කොමාන්ඩ් එකක් ටයිප් කරන්න කියනවා
    එතනින් එහාට සීඩෟ බූට් වෙන්නෙ නෑ.මෙන්න මෙතන ටයිප් කරන්න අවශ්‍ය මෛානවද

    [DR-DOS]A:\>මෙන්න මෙතන ටයිප් කරන්න අවශ්‍ය මෛානවද
     

    counter dr

    Member
    Dec 23, 2011
    1,993
    142
    0
    http://www.dslreports.com/forum/r23968242-C..


    Caldera DR-DOS Boot Disk

    I need to do a clean install of Windows XP from from a supplied boot disk. The instructions found on the disk in files ReadMe.htm and SetupXP.htm say to enter the following commands at the prompt, and I get an error message as thus:

    Caldera DR-DOS 7.03
    Copyright (c) 1976, 1998 Caldera, Inc. All rights reserved.
    [DR-DOS] A:\> D:
    [DR-DOS] D:\> cd \i386
    [DR-DOS] \I386 winnt32
    This program cannot be run in DOS mode.

    I get the same error message if I try to enter 'setup' or 'autorun', etc. However, the setup program runs fine if the disk is loaded onto a running windows OS. I have a copy of the windows XP SP3 saved as a .iso file. Perhaps someone could suggest a different boot loader?

    I give up. I need to ask for help on this. Any suggestions would be appreciated..........
     

    baba2

    Well-known member
  • Mar 12, 2013
    1,649
    44
    48
    ana macoo sinhalan ma tika dapan ko

    Caldera DR-DOS Boot Disk

    I need to do a clean install of Windows XP from from a supplied boot disk. The instructions found on the disk in files ReadMe.htm and SetupXP.htm say to enter the following commands at the prompt, and I get an error message as thus:

    Caldera DR-DOS 7.03
    Copyright (c) 1976, 1998 Caldera, Inc. All rights reserved.
    [DR-DOS] A:\> D:
    [DR-DOS] D:\> cd \i386
    [DR-DOS] \I386 winnt32
    This program cannot be run in DOS mode.

    I get the same error message if I try to enter 'setup' or 'autorun', etc. However, the setup program runs fine if the disk is loaded onto a running windows OS. I have a copy of the windows XP SP3 saved as a .iso file. Perhaps someone could suggest a different boot loader?

    I give up. I need to ask for help on this. Any suggestions would be appreciated..........
     

    baba2

    Well-known member
  • Mar 12, 2013
    1,649
    44
    48
    [DR-DOS] A:\> D:
    [DR-DOS] D:\> cd \i386
    disk write -protected kiyala anawa?
    [DR-DOS] \I386 winnt32
    3 code eka wada karanna naha? mema m.g eka anawa? invalid drive specified????